Cisco Cisco Tunnel Terminating Gateway (TTG) Fascicule
IPv6 ACL Configuration Mode Commands
▀ redirect css service (by ICMP packets)
▄ Cisco ASR 5x00 Command Line Interface Reference
6376
Important:
If the options specified do not exactly match an existing rule definition, the insertion point does not
change.
no
Removes the rule definition which exactly matches the options specified.
css service svc_name
The name of the Content Service Steering (CSS) service to which packets are to be redirected. At the
executive mode prompt, use the
executive mode prompt, use the
show css service all
command to display the names of all configured
charging services.
svc_name
must be an alphanumeric string of 1 through 15 characters.
log
Default: packets are not logged.
Indicates all packets which match the redirect are to be logged.
Indicates all packets which match the redirect are to be logged.
source_address
The IP address(es) form which the packet originated.
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
source_wildcard
parameter.
source_wildcard
This option is used in conjunction with the
source_address
option to specify a group of addresses for
which packets are to be filtered.
The mask must be entered as a complement:
The mask must be entered as a complement:
Zero-bits in this parameter mean that the corresponding bits configured for the
source_address
parameter must be identical.
One-bits in this parameter mean that the corresponding bits configured for the
source_address
parameter must be ignored.
Important:
The mask must contain a contiguous set of one-bits from the least significant bit (LSB).
any
Specifies that the rule definition applies to all packets.
host
Specifies that the rule definition applies to a specific host as determined by its IP address.
source_host_address
The IP address of the source host to filter against expressed in IPv6 colon-separated-hexadecimal notation.