Cisco Cisco Aironet 702W Access Point Guide De Montage
3
1
About this Guide
This Guide provides instructions on how to install and configure your Cisco Aironet 700W Series Access Point. The 700W Series
Access Point is referred to as the 700W series or the access point in this document.
Access Point is referred to as the 700W series or the access point in this document.
2
Introduction to the Access Point
The 700W series supports high-performing two spatial stream rates over a deployable distance with high reliability when serving
clients. The 700W series provides high reliability and overall wireless performance.
clients. The 700W series provides high reliability and overall wireless performance.
The 700W series offers dual-band radios (2.4 GHz and 5 GHz) with integrated internal antennas. The access point supports full
interoperability with leading 802.11n clients.
interoperability with leading 802.11n clients.
Note
For information on the 702W series’ model numbers and the supported regulatory domains, see
.
The 700W series access point is available in the controller-based configuration and supports:
•
Simultaneous dual-band (2.4 GHz/5 GHz) radios
•
Integrated internal antennas only
The features of the 700W series are:
•
Processing sub-systems (including CPUs and memory) and radio hardware which supports:
–
Unified
–
FlexConnect
–
Monitor-mode
–
VideoStream
–
Location (not available on autonomous or standalone models)
–
WIDS/WIPS (not available on autonomous or standalone models)
–
Security
–
Radio Resource Management (RRM) (not available on autonomous or standalone models)
–
Rogue detection (not available on autonomous or standalone models)
–
Management Frame Protection (MFP) (not available on autonomous or standalone models)
–
BandSelect (not available on autonomous or standalone models)
Note
Enhanced Local Mode (ELM) is not supported.
•
The following processor features:
–
128 MB NAND flash size
–
1 MB NOR flash size
–
128 MB DDR2 memory bus, x32
•
2.4 GHz and 5 GHz 802.11n radios with the following features:
–
802.11n standard compliant
–
A-MPDU TX
–
HT Duplicate Mode
–
2TX x 2RX
–
2-spatial streams, 300 Mbps PHY rate
–
Maximal ratio combining (MRC)
–
Cyclic Shift Diversity (CSD)