Cisco Cisco Prime Network Registrar 8.0 Guide De Dépannage
3.2 Production and DR Executive using different IPs
In this DR scenario the failed Production Executive is replaced
by the DR Executive, but the machines maintain separate IP
addresses because they are not on the same subnet or there is
no VLAN in place and no virtual IP technology is used. All
no VLAN in place and no virtual IP technology is used. All
deployed Agents are configured with the IP addresses of both
the production and DR executive using a “failover” setup.
the production and DR executive using a “failover” setup.
Production
Executive
DR Executive
2.2.2.2
All
Services
Started
Offline
1.1.1.1
DNS / DHCP
Agents
Figure 1. Agents “failover” from Production to DR Executive
3.2.1 Prerequisites
The following prerequisites must be met in order to support a
DR event or exercise under this scenario.
DR event or exercise under this scenario.
3.2.1.1 Cisco Prime Network Registrar IPAM 8.0 Agent Only Environment
This DR scenario is supported for Cisco Prime
Network Registrar IPAM Agent installations running in
Network Registrar IPAM Agent installations running in
8.0 Agent-only mode.
Run the following command on the Production
Executive to switch to 8.0 Agent-only mode:
Executive to switch to 8.0 Agent-only mode:
> $INCHOME/etc/support/removeSwiftMQSupport