Cisco Cisco Prime Performance Manager 1.5 Guide Du Développeur
Cisco Prime Performance Manager1.5 REST API Guide
The startDate/endDate and durationSelect parameters are mutually exclusive.
The default value is last24Hours for network level report, unless the intervalTypeKey parameter is
provided (refer to document section 4 Reports Default Time Durations).
provided (refer to document section 4 Reports Default Time Durations).
The default value is last12Hours for a specific node report, unless the intervalTypeKey parameter is
provided (refer to document section 4 Reports Default Time Durations).
provided (refer to document section 4 Reports Default Time Durations).
The durationSelect must be greater than intervalTypeKey.
Not supported by views.
Default values for durationSelect are based on intervalTypeKey -- refer to document section 4 Reports
Default Time Durations.
5.7.6 intervalTypeKey
Table 12 – intervalTypeKey Parameter
Parameter
Notes
intervalTypeKey
The average interval type for the measurements in the reporting data.
Possible values:
FIFTEEN_SECS
THIRTY_SECS
ONE_MINUTE
FIVE_MINUTE
QUARTER_HOUR
HOUR
DAY
WEEK
MONTH
Example:
intervalTypeKey=MONTH
Possible values:
FIFTEEN_SECS
THIRTY_SECS
ONE_MINUTE
FIVE_MINUTE
QUARTER_HOUR
HOUR
DAY
WEEK
MONTH
Example:
intervalTypeKey=MONTH
Additional Notes
Only supported in the “GET /{reportType}/{category}../{reportName}” requests.
By default, reports queried using second intervals (FIFTEEN_SECS, THIRTY_SECS) will display the
seconds in the timestamp. In that case the format for the timestamp will be:
seconds in the timestamp. In that case the format for the timestamp will be:
yyyy-MM-ddTHH:mm:ssZ (notice that the “ss” has been added to display seconds)
HOUR is the default for network reports; that is, when FQDN or sgmid are not given.
QUARTER_HOUR is the default for device reports; that is, either FQDN or sgmid is given.
Not supported by views.
5.7.7 showSeconds
Table 13 - showSeconds Parameter
Parameter
Notes
showSeconds
A boolean parameter thatdisplay seconds on the report timestamp column.
By default, except for (FIFTEEN_SECS, THIRTY_SECS) seconds interval,
reports do not show seconds in the timestamp column. If the user passes this
parameter with a value of “true”, the report shows the seconds, and the
timestamp is formatted as
yyyy-MM-ddTHH:mm:ssZ
By default, except for (FIFTEEN_SECS, THIRTY_SECS) seconds interval,
reports do not show seconds in the timestamp column. If the user passes this
parameter with a value of “true”, the report shows the seconds, and the
timestamp is formatted as
yyyy-MM-ddTHH:mm:ssZ