Cisco Cisco Prime Central 1.5.2 Guide De Montage

Integrating SpiderNet with Prime Central

Procedure

Step 1

From the Fault Source Management portlet, click Add to add the Fault Source details.
The Add New Fault Source dialog box appears.

Step 2

Enter the Fault Source Type from the drop-down as SpiderCloud and specify the Fault Source details in the appropriate
fields.

Step 3

Click OK.
For more Information about how to add a Fault Source and the field descriptions, refer to the section Adding a Fault
Source in the

Prime Central 1.5.2 User Guide.

After the SpiderNet Fault Source is added, SpiderNet is registered with Prime Central as a domain manager instance.

If SpiderNet is in HA mode, add two fault sources for standby and active IP addresses respectively.

Note

Configuring Prime Central as Trap Listener in SpiderNet to Receive Traps

Procedure

Step 1

Step 2

Create a SNMP Managers Group:

a) Choose Administration > Northbound Interface > New SNMP Manager Group.
b) Enter Prime Central details:

• In Port field, enter 1162 port number.

• In Host Names or IP Addresses field, enter Prime Central FM server hostname or IP address.

• Select Alarm Forwarding checkbox and in SNMP Version choose V2C. In Community, enter Public.

• Uncheck Enable the Heartbeat Trap check box, as this trap is not supported in Prime Central.

• Click OK.

Step 3

Configure Events:

a) Choose Administration > Fault Management > Events Configuration.
b) Select Forward to SNMP check box and choose Prime Central SNMP Manager group in the drop-down.
c) Click Save.

Step 4

Configure a Trap Target:

a) Choose Network Control > Services Nodes. Right click on the required node, go to Show Configuration > Advanced

> System > Event Management > Target. Right click on Target, and click Add Target.

• Provide Target Index and click OK.