Cisco PowerKEY CableCARD Module Guide De Montage
Chapter 4 Configure the PCG on the DNCS or ISDS
24
78-4017672-01 Rev E
Enabled—Indicates that the pkeManager process in the DNCS/ISDS is now
communicating with this particular PCG
communicating with this particular PCG
Alarm Threshold %/Security Level—At this time, alarms are not supported.
Keep this field at its default value
Keep this field at its default value
DNCS to PCG Message Timeout (Seconds)—This timeout is used to
indicate the period that the pkeManager process will wait for any
communication with the PCG before timing out. Values are 5 through 60
indicate the period that the pkeManager process will wait for any
communication with the PCG before timing out. Values are 5 through 60
CW_Provision Msg Repetition Rate (msgs per Crypto-Period)—This
repetition rate is used by the Event Information Scheduler (EIS) module
within the PCG. EIS is disabled and this field does not apply to the PCG
repetition rate is used by the Event Information Scheduler (EIS) module
within the PCG. EIS is disabled and this field does not apply to the PCG
ID—Indicates a unique value for a PCG device created on the DNCS/ISDS
Config File—The name of the configuration file that is downloaded at power
up by the "bootup" software. For example, pcg.cfg. This file contains the
following information:
up by the "bootup" software. For example, pcg.cfg. This file contains the
following information:
–
Name of the pcg software executable
–
Port to be used by the EIS component of the PCG
–
Port to be used by the ECMG component of the PCG
–
RPC (remote procedure call) server to contact when requesting a
provision
provision
Max Streams—The maximum number of ECM streams that indicates the
number of programs that can be encrypted. Values are 1 through 1000
number of programs that can be encrypted. Values are 1 through 1000
Default Gateway—IP address of the gateway so that the PCG can
communicate with the DNCS/ISDS or the SCS
communicate with the DNCS/ISDS or the SCS
Headend—The name of the headend at the site where the PCG is used. For
example, Headend_Site1
example, Headend_Site1
SCS Ethernet IP Address—The IP address for the interface on the PCG that
is used for communicating with the SCS on a private network
is used for communicating with the SCS on a private network
SCS Subnet Mask—The subnet mask for the interface on the PCG that is
used for communicating with the SCS on a private network
used for communicating with the SCS on a private network
SCS Default Gateway—The gateway for the interface on the PCG that is
used for communicating with the SCS on a private network
used for communicating with the SCS on a private network
SCS Test Timeout (Seconds)—This timeout is used by the EIS module
within the PCG. When the EIS module is enabled within the PCG and if there
are no messages from the SCS within the SCS test timeout period, the EIS
within the PCG. When the EIS module is enabled within the PCG and if there
are no messages from the SCS within the SCS test timeout period, the EIS