Cisco 1GHz Surge-Gap Taps, Standard & Full Profile Guide De Montage
Chapter 2 Installing the Tap/Passive
Installing the Drop Cable
To install the drop cable, follow the steps below.
1. Slide the weatherproofing material over the end of the drop cable for later use.
2. Attach the appropriate F-connector to the drop cable end per the manufacturer’s
1. Slide the weatherproofing material over the end of the drop cable for later use.
2. Attach the appropriate F-connector to the drop cable end per the manufacturer’s
recommended procedure.
3. Remove the factory installed protective plastic cap from the appropriate F-port
where the connection is to be made.
4. Connect the house drop F-connector to the F-port.
5. Using a 7/16-in. wrench, tighten the connector to a maximum of
5. Using a 7/16-in. wrench, tighten the connector to a maximum of
25 in-lbs (2.8 Nm).
6. Dress the drop cable and secure as applicable.
28
OL-31976-01