Cisco Cisco Surge-Gap Passives Guide De Montage

78-589863-01 Rev C 

Alpha Amp Clamp for Power Inserter Installation Instructions 

5 

Continued

 

(continued)

  

 

7 

Align the power inserter faceplate with the power inserters housing. 

Ensure that the housing alignment tab on the faceplate and power 

inserter housing match. Carefully press the two halves together. 
Note: The metal standoff mating prongs on the amp clamp must snap 

between both standoff clips on the faceplate. 

8 

Using a 3/8-in. nut driver, tighten the faceplate’s four captive bolts from 

50 in-lb to 60 in-lb (5.6 Nm to 6.8 Nm). 

9 

If you have a 750 MHz power inserter use the following label: 

 

 

If you have a 1 GHz power inserter use the following label: 

 

 

If you have a high current power inserter use the following label: 

 

10 

Clean the label area on the surface of the power inserter (remove dust, 

etc.). Remove the adhesive backing of the product/serial number label 

from the retrofit kit and place on the exterior of the power inserter 

housing.