Cisco Cisco Content Delivery Engine 110 Références techniques
MegaRAID SAS Controller Replacement Procedure
OL-27138-01
All contents are Copyright © 2012 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
41
Figure 47: LSI Reboot prompt
11.
If the prompt to import the “Foreign configuration” was not seen, verify the configuration
by loading the WebBIOS when
by loading the WebBIOS when
prompted by entering “<CNTL>-H”. Follow the same
procedure as mentioned after Figure 42 (Figure 42 through 47).
Figure 48: MegaRAID controller card correct initialization and Firmware
Post-Upgrade Procedure for Persistent Stores:
1. Check for LED status on the interface ports
2.
When the Library starts it’s POST procedure, enter the system BIOS setup by pressing
<DELETE> within the first 10 seconds and while the “enter BIOS” option is displayed on
the screen. When in the BIOS confirm the following elements below, save the BIOS
settings and reboot.
<DELETE> within the first 10 seconds and while the “enter BIOS” option is displayed on
the screen. When in the BIOS confirm the following elements below, save the BIOS
settings and reboot.
Advanced -> Console Redirection:
Console Type is set to VT100