Cisco Surge-Gap Drop Amplifier with 65 86 MHz split Guide De Montage
2
Surge-Gap Drop Amplifier Quick Install Sheet
78-4000255-01 Rev C
Surge-Gap Drop Amplifier Quick Install Sheet,
Continued
Power Inserter
The power inserter is used with outdoor
installations.
75 ohm Terminators
Terminators must be installed on any
unused output ports to reduce noise
getting into the cable network.
3-foot Coaxial Cable
The coaxial cable connects the AC adapter to the drop amplifier.
Installation Screws (2)
The screws are used to attach the drop amplifier to the wall.
Indoor Installation
Follow the steps below to install the drop amplifier inside the home.
Note: The power inserter (provided) is not used for indoor installations.
Note: The power inserter (provided) is not used for indoor installations.
1.
Locate the drop amplifier near the drop cable and a 120 V AC or 240 V AC outlet.
Look for the areas where the cable enters the home or is split for devices. This is
typically in the basement or the attic. You may also find a termination within a
network interface box (gray box) on the outside of your home.
2.
Mount the drop amplifier to a stud or wall using the installation screws.
3.
Make all connections to the drop amplifier as shown in the diagram below.
4.
Plug the AC adapter into the AC outlet.
Continued on next page