Cisco Headend System Release 2.5 Mode D'Emploi
1-16
DHCT Status Reporting Utility
78-738186-01 Rev B
Poll DHCTs
Introduction
The instructions in this section describe how to use the DHCT Status Reporting
Utility to poll DHCTs.
Note: All procedures in this section assume that the DHCT Status Reporting Utility
Note: All procedures in this section assume that the DHCT Status Reporting Utility
screen is open on the DNCS.
Polling DHCTs
Follow these instructions to poll the DHCTs on the system.
1.
From the DHCT Status Reporting Utility screen, type p and then press Enter.
Result: The DHCT Polling Menu screen appears.
Result: The DHCT Polling Menu screen appears.
2.
Choose one of the following options:
•
•
To poll all active DHCTs on the network, go to Polling All Active DHCTs,
next in this section.
•
To poll DHCTs associated with a specific QPSK modulator or demodulator,
go to Polling DHCTs per QPSK Modulator or Demodulator, later in this
section.
Note: The first time you run the DHCT Status Reporting Utility, you must
poll all active DHCTs.