Cisco Headend System Release 2.5 Guide De Montage
78-738190-01 Rev B
SR 2.5/3.5 Direct ASI Installation and Configuration Procedures
I-3
Install the ASI Card
Installing the ASI Card
After deleting (if necessary) the ASI package from the DNCS, follow these
instructions to install the ASI card.
1. Follow these instructions, if necessary, to log on to the xterm window as
root user.
Note: If you had to remove the ASI package in the previous procedure, you
Note: If you had to remove the ASI package in the previous procedure, you
should already be root user.
a) Type su - and then press Enter.
a) Type su - and then press Enter.
Result: The password prompt appears.
b) Type the root password and then press Enter.
2. Type shutdown -y -g0 -i0 and then press Enter.
The DNCS shuts down and the ok prompt appears.
3. Turn off power to the DNCS.
4. Remove the cover to the DNCS and install the ASI card into one of the
following slots:
•
•
Slot 2 if you have an Enterprise 250 DNCS
•
Slot 5 if you have an Enterprise 450 DNCS
•
Slot 7 if you have a Sun Fire V880 DNCS
5. Put the cover back on the DNCS.
6. Turn on power to the DNCS.
7. Log on to the DNCS as root user.
8. Did the DNCS processes start after you turned on the power?
•
If yes, follow the Stopping the DNCS procedure in Appendix A to stop
the DNCS; then go to Install the ASI Package, next in this appendix.
•
If no, go to Install the ASI Package, next in this appendix.