Cisco Headend System Release 2.7 Mode D'Emploi
Remove the Inband BFS Carousel from the BIG PAT Table
4001182 Rev B
43
Remove the Inband BFS Carousel from the BIG
PAT Table
PAT Table
Overview
This section describes the procedures for removing an inband BFS carousel from the
BIG PAT Table.
BIG PAT Table.
Deleting the Application From the BIG PAT Table
Important! Before you begin this procedure, make sure you know the source ID for
the application source.
1 From the DNCS Administrative Console, click the DNCS tab.
2 Does your system include a BIG (your system is not using an ASI card)?
the application source.
1 From the DNCS Administrative Console, click the DNCS tab.
2 Does your system include a BIG (your system is not using an ASI card)?
If yes, click the Network Element Provisioning tab and then click BIG. The
BIG List window opens.
BIG List window opens.
If no, go to step 5.
3 From the BIG List window, double-click the BFS BIG. The Set Up BIG window
opens.
4 Click PAT Configuration to open the BIG PAT window and go to step 8.
5 From the DNCS Administrative Console, click Application Interface Modules,
5 From the DNCS Administrative Console, click Application Interface Modules,
and click BFS Admin. The BFS Administration window opens.
6 Select the appropriate host, click File and select Open. The Set Up BFS Host
window opens.
7 Click PAT Configuration. The Inband Data PAT window opens.
8 Select the application session you want to delete and click Delete Entry. A
8 Select the application session you want to delete and click Delete Entry. A
message appears and prompts you to confirm the deletion request.
9 Click Yes to confirm the deletion. A confirmation message appears.
10 Click OK.
11 Do you need to delete an additional inband data carousel?
10 Click OK.
11 Do you need to delete an additional inband data carousel?
If yes, repeat steps 8 through 10.
If no, go to step 12.