Cisco Headend System Release 2.7 Mode D'Emploi
Chapter 3 Delete BFS Sources
48
4001182 Rev B
Verify the Number of Sessions After Deleting an
Inband Source
Inband Source
Overview
This section describes how you can ensure that the inband source was successfully
removed from your system.
removed from your system.
Verifying the Number of Sessions on the QAM
Important! If your system is running in an RCS environment, you will need to locate
the respective QAM in which the session was removed.
1 Facing the front of the QAM modulator, press the OPTIONS button to cycle
the respective QAM in which the session was removed.
1 Facing the front of the QAM modulator, press the OPTIONS button to cycle
through the QAM menu screens until you see the Session Count screen.
Example: The following diagram shows an example of the Session Count screen.
Example: The following diagram shows an example of the Session Count screen.
2 Record the number of sessions in the space provided.
Total Session Count: _______
3 Did the session count decrease appropriately from the value you recorded in
Verify the Number of Sessions Before Deleting an Inband Source (on page 36)?
If yes, you have successfully completed these procedures.
If no, call Cisco Services.