Cisco Headend System Release 2.5
Appendix D
Direct ASI Rollback Procedures
138
4000916 Rev C
Configure the Front Panel of the BFS QAM
Configuring the Front Panel of the BFS QAM
In this procedure, you will inspect the front panel of the BFS QAM to confirm that
the BFS QAM is indeed configured for SWIF. If the front panel reveals that the BFS
QAM is not configured for SWIF, you need to manually configure it. The following
procedure guides you through the necessary steps.
1 Press the Options button on the front panel of the BFS QAM until Input
the BFS QAM is indeed configured for SWIF. If the front panel reveals that the BFS
QAM is not configured for SWIF, you need to manually configure it. The following
procedure guides you through the necessary steps.
1 Press the Options button on the front panel of the BFS QAM until Input
Selection appears.
2 Does the Input Selection field reveal that the BFS QAM is configured for SWIF?
If yes, skip the remainder of this procedure and go to Configure Inband Data
(on page 139).
(on page 139).
If no, continue with step 3.
3 Press the up or down arrow button until SWIF appears in the Input Selection
field.
4 Press Enter to save the newly configured BFS QAM.