Cisco Headend System Release 2.7 Guide De Montage
Setting Up PassThru PID Routes
78-4036705-01 Rev D
103
Setting Up PassThru PID Routes
There might be situations where you need to provision data sources for PID Routes
(passthru PIDs) for PSIP, EAS, and other data, rather than using TSRs to pass the
data through the entire transport stream.
(passthru PIDs) for PSIP, EAS, and other data, rather than using TSRs to pass the
data through the entire transport stream.
Using passthru PID routes allows the data to flow through the QAM on carriers that
contain DTA-related content. When you provision passthru PID routes for BSG-
associated QAM carriers with active content, the DTACS sets up additional PID
routes (AMM, SI/CVT with user-defined PID route sources) on those QAM carriers.
contain DTA-related content. When you provision passthru PID routes for BSG-
associated QAM carriers with active content, the DTACS sets up additional PID
routes (AMM, SI/CVT with user-defined PID route sources) on those QAM carriers.
In order to set up a passthru PID route, you must first create the PID route source
and then add a PID to that route.
and then add a PID to that route.
Create a PassThru PID Route
Follow these instructions to add a passthru PID source to a PID route in the DTACS.
1 In the Network Elements section, click PID Route Provisioning. The PID Route
1 In the Network Elements section, click PID Route Provisioning. The PID Route
Provisioning window opens, listing the PID routes available to the DTACS.