Cisco Headend System Release 2.7 Guide De Montage
Log On to the DTACS Server
78-4036705-01 Rev D
13
Log On to the DTACS Server
Important: These instructions assume that the DTACS server has not yet been
configured.
configured.
Complete the following steps to connect a laptop to the DTACS server and configure
the network management port.
1 Connect a laptop computer to the serial management port of the DTACS server.
2 Start the HyperTerminal application on the laptop and configure the application
the network management port.
1 Connect a laptop computer to the serial management port of the DTACS server.
2 Start the HyperTerminal application on the laptop and configure the application
with the following parameters:
Note: The HyperTerminal application allows one computer to communicate with
another computer.
Note: The HyperTerminal application allows one computer to communicate with
another computer.
Baud rate-9600
Data bits-8
Parity-none
Stop bit-1
Flow control-no
Note: You must connect your laptop to the serial management port on the
DTACS server to configure the server's network management port.
DTACS server to configure the server's network management port.
3 If necessary, power on the DTACS server.
4 From the login prompt on the terminal, log on with the username root and the
4 From the login prompt on the terminal, log on with the username root and the
password changeme. The -> prompt appears. This is the prompt for the ILOM
command line interface (CLI).
command line interface (CLI).
5 Do you want to change the ILOM root password?
If yes, type set /SP/users/root password and press Enter. Go to step 6.
If no, go to Configure the Service Processor Network Management Port (on
page 14).
page 14).
6 When prompted, enter the new password, and then enter it a second time.