Cisco Headend System Release 2.7 Mode D'Emploi
Run the getEASdata Utility
4031374 Rev B
73
3 Type 1 (for Report EAS Errors) and then press Enter. The utility displays a
confirmation message about several conditions that must be true before you
should run the report.
should run the report.
Note: These conditions were discussed in Before Running the getEASdata
Utility (on page 71).
Utility (on page 71).
4 Type y and then press Enter.
5 Type the IP address of a test DHCT that did not receive the EAS message, and
5 Type the IP address of a test DHCT that did not receive the EAS message, and
then press Enter.
Note: If you fail to provide an IP address, the utility will still run but it will not
provide data in the EAS data on a DHCT section of the EAS Error Report.
Result: The following message appears:
Enter the diagnostic screen the EAS data is on and/or hit return to continue.
Note: If you fail to provide an IP address, the utility will still run but it will not
provide data in the EAS data on a DHCT section of the EAS Error Report.
Result: The following message appears:
Enter the diagnostic screen the EAS data is on and/or hit return to continue.