Cisco Headend Digital Broadband Delivery System Mode D'Emploi
3-14
Channel Selection Options
4002178 Rev C
Select Channel 3 or 4 for the RF Output on the Set-Top,
Continued
9.
Select the Base Application tab to select the RF output channel for all your
subscribers.
Result: The Base Application tab appears in the forefront.
Result: The Base Application tab appears in the forefront.
10. For the RF Output Channel option, select either channel 3 or 4.
11. Click Save.
11. Click Save.
Result: All of your subscribers’ set-tops will now use the RF output channel
that you selected. Subscribers can use the General Settings Menu to change
the RF output channel.
12.
Click Cancel.
Result: The DHCT Configure prompt opens.
Result: The DHCT Configure prompt opens.
13.
Click File and Close to close the DHCT Configure prompt.
Selecting the RF Output Channel for the Set-Top for Your Subscribers
To select the RF output channel for your subscribers, complete the following steps.
Note: To allow subscribers to designate the RF output channel for the set-top, see
Note: To allow subscribers to designate the RF output channel for the set-top, see
Allowing Subscribers to Select the RF Output Channel for the Set-Top, earlier in
this section.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click DHCT Config.
Result: The DHCT Configure Prompt window opens.
Result: The DHCT Configure Prompt window opens.
3.
Select Global.
Result: The Set Up Global DHCT Configuration window opens.
Result: The Set Up Global DHCT Configuration window opens.
4.
Select the General Settings tab.
Result: The General Settings tab appears in the forefront.
Result: The General Settings tab appears in the forefront.
5.
Make sure the option for RF Output Channel is not selected.
Result: When this field is not selected, subscribers cannot select the RF
Result: When this field is not selected, subscribers cannot select the RF
Output channel for the set-top. Instead, you must select the RF output
channel for the subscriber.
6.
Select the Base Application tab to select the RF output channel for all your
subscribers.
Result: The Base Application tab appears in the forefront.
Result: The Base Application tab appears in the forefront.
7.
For the RF Output Channel option, select either channel 3 or 4.