Cisco Headend System Release 2.7 Mode D'Emploi
Add Source IDs for SDV Services in an RNCS Environment
4024447 Rev C
93
6 Enter the appropriate values in the following fields:
Bandwidth (Mbps): Enter the bandwidth rate for the SDV service.
Netcrypt: Select the Netcrypt device for the remote location that will be
multicasting the content for this service group.
multicasting the content for this service group.
Netcrypt Port: Select the Netcrypt GbE port that will be multicasting the
content (the same port that is receiving the content from the staging
processor or other source).
content (the same port that is receiving the content from the staging
processor or other source).
MPTS: The incoming stream to the Netcrypt is Multi Program Transport
Stream (MPTS).
Important: In an SDV environment, SPTS (Single Program Transport Stream)
should be the standard; therefore, MPTS should never be enabled.
Stream (MPTS).
Important: In an SDV environment, SPTS (Single Program Transport Stream)
should be the standard; therefore, MPTS should never be enabled.
SDV Session: Do not enable this option.
Program Number (is active only when MPTS is selected): You do not need to
enter a program number in an SDV environment. Go to step 7.
enter a program number in an SDV environment. Go to step 7.
7 Select or enter the following values for the stream delivery type you selected in
step 6:
INPUT
INPUT
Multicast: Select Multicast.
Source IP Address 1 (optional): The IP address of the staging processor (for
example, DCM, Mentor, BMR, or Terayon device) interface that is sourcing
the video at the remote site.
example, DCM, Mentor, BMR, or Terayon device) interface that is sourcing
the video at the remote site.
Source IP Address 2 (optional): The IP address of an additional staging
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
Source IP Address 3 (optional): The IP address of an additional staging
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
Destination IP Address: The destination IP address of the multicast stream
incoming to the Netcrypt device.
incoming to the Netcrypt device.
UDP Port: The destination UDP port number for the incoming content.
OUTPUT
Multicast: Select Multicast.
Destination IP Address: The multicast IP address for the destination output
source that the Netcrypt device is sending video to.
source that the Netcrypt device is sending video to.
Output (optional): The destination UDP port that the Netcrypt device will
use when sending the content to the network.
use when sending the content to the network.
8 Click Save.