Cisco Headend System Release 2.7 Manuel De Maintenance
Chapter 1 Staging Preparation
26
4024836 Rev D
10 Click in the Bidirectional Timeout (decimal seconds) and enter the number of
seconds the two-way CableCARD host waits to displays the CP MMI screen after
the host determines that it cannot connect to the DNCS or receive a response
from the DNCS.
Note: We recommend that you set the Bidirectional timeout to 180 seconds (3
Note: We recommend that you set the Bidirectional timeout to 180 seconds (3
minutes).
11 Click Save.
12 Click Exit to close the CableCARD Data Summary screen.
12 Click Exit to close the CableCARD Data Summary screen.
Turning Off Autobinding
1 On the DNCS Administrative Console, select the DNCS tab.
2 Select the Home Element Provisioning tab.
3 Click CableCARD. The CableCARD Filter screen opens.
4 Click Configure CableCARD Server. The Configure CableCARD Server screen
1 On the DNCS Administrative Console, select the DNCS tab.
2 Select the Home Element Provisioning tab.
3 Click CableCARD. The CableCARD Filter screen opens.
4 Click Configure CableCARD Server. The Configure CableCARD Server screen
opens.
5 Enter the following information into the appropriate fields within the Configure
CableCARD Server screen:
IP Address—Type all zeros for the IP Address: 0.0.0.0
Port Number—Type a zero for the Port Number: 0
6 Click Save to save these parameters.
7 Click the CableCARD Summary link at the top of the page. The CableCARD
7 Click the CableCARD Summary link at the top of the page. The CableCARD
Summary screen opens.
8 Click MMI Screen Format. The Configure Copy Protection MMI Screen opens.
9 Make sure that the Display MMI for Bi-Directional Device is activated (that a
9 Make sure that the Display MMI for Bi-Directional Device is activated (that a
checkmark displays in the box).