Cisco Headend System Release 2.7 Mode D'Emploi
Chapter 2 Configure the DREDD Proxy Server
8
4022451 Rev D
Add FTP DREDD Proxy Server Route to File
To ensure that the route is added during DNCS reboots, you must add the FTP
proxy server route to the /etc/rc2.d/S82atminit file.
proxy server route to the /etc/rc2.d/S82atminit file.
Important: You must direct your internal network support representatives to add a
public IP address that will allow external access to the DREDD Service. If you have
any questions, contact the representative who handles your account.
public IP address that will allow external access to the DREDD Service. If you have
any questions, contact the representative who handles your account.
Complete the following steps:
1 Open an xterm window.
2 At the prompt, type su - and press Enter. A password prompt appears.
3 Type the root user password and press Enter. A prompt for the root user
1 Open an xterm window.
2 At the prompt, type su - and press Enter. A password prompt appears.
3 Type the root user password and press Enter. A prompt for the root user
appears.
4 Type /usr/sbin/route add xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy 1 and press Enter.
Note:
xxx.xxx.xxx.xxx represents the public IP address of the DREDD Server
yyy.yyy.yyy.yyy represents the IP address of the gateway used to reach the
DREDD Server
DREDD Server
1 is the hop count value that specifies a "gateway" route
5 To make these route changes permanent, add them to /etc/rc2.d/S82atminit as
shown in the following example:
/usr/sbin/route add xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy 1 # DREDDProxy Server