Cisco Headend System Release 2.7
Chapter 1 Introducing System Release 2.7/3.7/4.2 SP 0.2
4
4019303 Rev C
Implemented Change Requests
This list highlights some of the major improvements to the DNCS since the release of
SR 2.7/3.7/4.2. Contact your Cisco marketing manager for additional details on any
of these change requests (CRs).
SR 2.7/3.7/4.2. Contact your Cisco marketing manager for additional details on any
of these change requests (CRs).
CR 62542: DSM Process on DNCS No Longer Crashes
Cisco has corrected a condition that caused an occasional crash of the DSM process
on the DNCS.
on the DNCS.
CR 63755: QAM Channels Calculate Bandwidth Correctly After Reboot
When a QAM modulator reboots, the bandwidth is calculated correctly for the QAM
channels.
channels.
CR 63777: DRM Process Allocates Bandwidth to a Third-Party QAM Channel
If the DNCS operator is selecting a third-party QAM channel from a service group,
the DRM process now correctly allocates bandwidth.
the DRM process now correctly allocates bandwidth.
CR 63897: DRM Process Releases a Third-Party QAM Session
When a session for a third-party QAM is released, the DRM process handles the
release correctly.
release correctly.
CR 63957: Adding or Deleting QAM Ports No Longer Causes the bfsRemote Process to Go into a
Recovery State
Recovery State
If the DNCS operator is adding and deleting several QAM ports to a service group,
the bfsRemote process no longer goes into a recovery state and set-tops continue to
receive information from the DNCS.
the bfsRemote process no longer goes into a recovery state and set-tops continue to
receive information from the DNCS.
CR 64409: The qamManager Logs No Longer Show Errors If Changes are Made on the QAM GUI
If the DNCS operator makes changes on the QAM GUI, the changes save correctly
and the qamManager logs do not show errors.
and the qamManager logs do not show errors.
CR 64455: The camEx and camPsm Process Operate Correctly After Setting Up VOD with A
Netcrypt Device
Netcrypt Device
The camEx and camPsm process remain running after rebooting a Netcrypt device
set up for VOD.
set up for VOD.
CR 64714: Enabling SSP2.3 Support Allows Third-Party QAMs to Receive the Correct Program
Number
Number
Third-party QAMs now receive the correct program number if SSP2.3 support is
enabled, which allows subscribers to see video.
enabled, which allows subscribers to see video.