Cisco Headend System Release 2.7
Chapter 2 DNCS Pre-Upgrade Procedures
28
4019303 Rev C
Stop System Components
Before installing SARA Server software, use the procedures in this section to stop
system components in the proper order. Failing to stop system components in the
order described in this section may cause you to encounter difficulties during the
installation.
system components in the proper order. Failing to stop system components in the
order described in this section may cause you to encounter difficulties during the
installation.
Important! System components must be stopped prior to installing SARA Server
software.
software.
Introduction
Before continuing with the installation process, follow the instructions in this section
to stop the Spectrum Network Management Service (Spectrum), the Application
Server, and the DNCS.
to stop the Spectrum Network Management Service (Spectrum), the Application
Server, and the DNCS.
Stopping Spectrum
1 From the DNCS Administrative Console Status window, click Control in the
NMS section of the window. The Select Host to run on window appears.
2 Select the appropriate Host Machine and then click OK. The Spectrum Control
Panel appears.
3 Click Stop SpectroSERVER. A confirmation message appears.
4 Click OK at the confirmation message. The Status message on the Spectrum
4 Click OK at the confirmation message. The Status message on the Spectrum
Control Panel shows Inactive.
5 Click Exit on the Spectrum Control Panel. A confirmation message appears.
6 Click OK at the confirmation message. The Spectrum Control Panel closes.
6 Click OK at the confirmation message. The Spectrum Control Panel closes.