Cisco Headend System Release 2.7 Guide De Dépannage
Chapter 6 Conduct EAS Tests
60
4024428 Rev B
18 Click the Send Message To tab. The Send Emergency Alert System Message
window updates with the Send Message To tab to the forefront.
19 Did you purchase the optional FIPS filtering software product for your system?
If no, go to step 20.
If yes, go to step 21.
20 Your only option is to select All States. Select All States, then go to step 25.
21 Click the State arrow and select the state the EOM message is sent to.
21 Click the State arrow and select the state the EOM message is sent to.
Important: You can stop all active EAMs by sending an EOM to All States.
Note: There will be no interference with services if a DHCT that does not have
Note: There will be no interference with services if a DHCT that does not have
any active EAMs receives an EOM.
22 Click the County arrow and select the county in the selected State the EOM
message is sent to.
23 Click the Subdivision arrow and select the subdivision of the selected county the
EOM message is sent to.
24 Click Add.
25 Is the content of the Selected FIPS Code window correct?
25 Is the content of the Selected FIPS Code window correct?
If yes, click Send.
If no, correct the information and click Send.
Important: If your system is currently broadcasting multiple EAMs, be sure you
terminate the correct message.
Note: To remove any destination from the Selected FIPS Code window,
Note: To remove any destination from the Selected FIPS Code window,
highlight this destination and click Remove.
Result: The ISDS transmits instructions to DHCTs to stop displaying the EAM.
Result: The ISDS transmits instructions to DHCTs to stop displaying the EAM.
26 Click Cancel on the Send Emergency Alert System Message window. The
window closes.