Cisco Cisco DOCSIS EuroDOCSIS Transponder for GainMaker Nodes Guide De Montage
Chapter 2 Installation and Configuration
Mounting
To Mount the Transponder
Mounting Steps:
1. Insert the transponder in the Transponder Module Slot of the desired device.
Make sure to position the transponder in the correct direction before installation,
by matching its PCB edge into the PCB Slot.
(Cisco Compact Dual Amplifier taken as the device for example)
(Cisco Compact Dual Amplifier taken as the device for example)
Important Note: Make sure that the transponder is inserted in the correct slot.
Note: If the transponder is mounted to the device in an operating CMTS system,
Note: If the transponder is mounted to the device in an operating CMTS system,
certain LEDs will flash to display the startup process, the upstream and
downstream status. See the Checking the LEDs section, on page 2-8 for details.
2. Push down on the transponder until it clicks into the connectors of the device.
Note: For Cisco Compact Segmentable Node A90200 and A90201, the following
mounting bracket is used for installing the transponder.
Follow the steps below to mount the bracket.
a) Insert the transponder and push down till it clicks into connectors.
b) Insert the mounting edge into the mounting bracket slot on the design print.
a) Insert the transponder and push down till it clicks into connectors.
b) Insert the mounting edge into the mounting bracket slot on the design print.
PCB Slot
Transponder Module Slot
Connector
Mounting Edge
Mounting Screw
Mounting Bracket Slot
12
OL-31165-02