Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 3 USRM Web Interface
106
4039132 Rev B
Parameter
Description
ForceSwitchover
Allows you to force a switchover. Selecting the On state
causes the standby server to transition to online, forcing
the primary offline if the standby is ready to take over for
the primary server.
causes the standby server to transition to online, forcing
the primary offline if the standby is ready to take over for
the primary server.
Note: Control is returned when the primary server comes
back online.
back online.
ProtectMode
Indicates if automatic switching is to be performed.
When set to the Auto state, the standby will protect the
primary in the event of a failure. When set to Manual
mode, the standby will not automatically protect the
primary in the event of a failure.
When set to the Auto state, the standby will protect the
primary in the event of a failure. When set to Manual
mode, the standby will not automatically protect the
primary in the event of a failure.
ServerName
The name of the primary server.
ConnectTime
The date and time that the standby connected to the
primary.
primary.
TransferStatus
Indicates the state of the connection, as follows:
WaitConnect - Indicates the standby is attempting to
connect to the primary server.
connect to the primary server.
Transfer - Indicates the database transfer is in progress.
Sync - Indicates the database has been completely
transferred, the standby and primary are synchronized,
and the standby is ready to assume control for the
primary in the event of primary failure or forced
switchover.
transferred, the standby and primary are synchronized,
and the standby is ready to assume control for the
primary in the event of primary failure or forced
switchover.
LinkStatus
The status of the connection. The OK state indicates
communication is valid. The Alarm state indicates the
connection has failed. This parameter transitioning to the
Alarm state is the trigger for the switchover.
communication is valid. The Alarm state indicates the
connection has failed. This parameter transitioning to the
Alarm state is the trigger for the switchover.
DatabaseStatus
Indicates whether the entire database has been obtained.
The Ready state indicates the entire database was
received and that the standby can replace the primary if
required.
The Ready state indicates the entire database was
received and that the standby can replace the primary if
required.