Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

 

xii 

4039132 Rev B 

Know the following safety warnings and guidelines: 

 

Dangerous Voltages 

Only qualified service personnel are allowed to perform equipment 
installation or replacement. 

Only qualified service personnel are allowed to remove chassis covers and 
access any of the components inside the chassis. 

 

Grounding 

Do not violate the protective grounding by using an extension cable, power 
cable, or autotransformer without a protective ground conductor. 

Take care to maintain the protective grounding of this equipment during 
service or repair and to re-establish the protective grounding before putting 
this equipment back into operation. 

 

When selecting the installation site, comply with the following: 

 

Protective Ground - The protective ground lead of the building‟s electrical 
installation should comply with national and local requirements. 

 

Environmental Condition – The installation site should be dry, clean, and 
ventilated. Do not use this equipment where it could be at risk of contact with 
water. Ensure that this equipment is operated in an environment that meets the 
requirements as stated in this equipment‟s technical specifications, which may be 
found on this equipment‟s data sheet. 

 

 

 

WARNING: 
Allow only qualified service personnel to install this equipment.  The 
installation must conform to all local codes and regulations. 

 

 

 

WARNING: 
Avoid personal injury and damage to this equipment. An unstable mounting 
surface may cause this equipment to fall. 

To protect against equipment damage or injury to personnel, comply with the 
following: 

 

Install this equipment in a restricted access location.