Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

 

4039132 Rev B 

291 

 

/etc/sysconfig/network-scripts/route-eth0 

GATEWAY0=10.0.0.1

 

NETMASK0=255.0.0.0

 

ADDRESS0=10.0.0.0

 

GATEWAY1=10.0.1.1

 

NETMASK1=255.255.255.0

 

ADDRESS1=192.168.1.0

 

3  Save the modified file and either reboot the system or restart networking by 

entering: 

service network restart

 

 

The USRM uses a watchdog application to monitor up time and to manage the 
upgrading of the USRM.  Once the USRM software is installed, the watchdog starts 
automatically on boot. 

Important:  The watchdog never needs to be shutdown or restarted.  The following 
section is for system maintenance only and should never be required during normal 
system operation. 

Note:  If you start the watchdog manually, it will not start the USRM.  Once the 
watchdog has been started, you can start the USRM manually.  From that point on, 
the watchdog will monitor the USRM. 

The watchdog can be manually stopped and started using the tnoswdog startup 
script located in the /etc/init.d directory.  Type the script command, with desired 
option, at the system prompt and press Enter. 

The script can be run with the following options: 

/etc/init.d/tnoswdog start

 

Starts the watchdog. 

/etc/init.d/tnoswdog stop

 

Stops the watchdog.  The USRM continues 
to run but the watchdog no longer 
maintains it. 

/etc/init.d/tnoswdog restart

 

Restarts the watchdog. 

/etc/init.d/tnoswdog status

 

Displays the status of the watchdog.  The 
status displays whether the watchdog was 
previously started or stopped.