Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 4 Operation
310
4039132 Rev B
Generic QAM Setup
Perform the following steps to set up a generic QAM.
1 Expand the ResourceManager - QAMs branch in the USRM web interface and
1 Expand the ResourceManager - QAMs branch in the USRM web interface and
select the QAM <QamName> - Chassis page.
Note: In this example, the QAM is named QAM D5-415.
Enter the CtrlIPAddress, Protection, AdminState and OverheadBandwidth, and
then click Commit Changes.
Note: In this example, the QAM is named QAM D5-415.
Enter the CtrlIPAddress, Protection, AdminState and OverheadBandwidth, and
then click Commit Changes.
2 Select the ResourceManager - QAMs - QAM <QamName> - Edge Inputs page.
3 Enter the IP Address(es), and then click Commit Changes.
3 Enter the IP Address(es), and then click Commit Changes.