Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 4 Operation
316
4039132 Rev B
Removing a QAM Chassis From the USRM
Perform the following steps to remove a QAM chassis from the USRM.
1 Select the Resource Manager - QAMs - QAM <QamName> - Output Ports page,
1 Select the Resource Manager - QAMs - QAM <QamName> - Output Ports page,
where QamName is the name of the QAM to be removed.
2 Set the AdminState to Release and click Commit Changes.
Result: This releases all sessions on all output ports of the QAM.
3 Set the AdminState to Delete and click Commit Changes.
Result: This removes the QAM from the USRM database.
4 Refresh the navigation tree and verify that the QAM is gone.
Note: In a DNCS 4.2.0 system, once a GQAM is removed from a USRM, you should
update the DNCS Service Group page(s) by removing the GQAM TSIDs from the
Selected Ports window and placing them back into the Available Ports window. For
a system running DNCS release 4.2.1 or greater, this is also applicable to any third
party QAMs that are being used or shared by the DNCS and USRM.
update the DNCS Service Group page(s) by removing the GQAM TSIDs from the
Selected Ports window and placing them back into the Available Ports window. For
a system running DNCS release 4.2.1 or greater, this is also applicable to any third
party QAMs that are being used or shared by the DNCS and USRM.