Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 5 Advanced Operations
362
4039132 Rev B
Note: You will be prompted for the password for the USRM. The default
password is "generic".
password is "generic".
Releasing Sessions From a Service Group in Resource Manager
Perform the following steps to release all sessions from a service group in resource
manager.
1 Select the ResourceManger - Software page.
2 In the ConfigFileUpdate field, enter "sgRelease_Servername.txt".
manager.
1 Select the ResourceManger - Software page.
2 In the ConfigFileUpdate field, enter "sgRelease_Servername.txt".
Note: Use your specific file name if different than our example. Don't include
quote marks.
quote marks.
3 Select "Read" in the ConfigFileUpdate field's drop-down list and then click
Commit Changes.
4 Refresh the navigation tree by either clicking the top-level USRM name or by
clicking the web browser's refresh button.
5 Monitor the EventLog to verify that the configuration file was read and that
sessions are deleted.
6 Select the Resource Manager - Service Groups:Config page and verify that the
AdminState of the service group is now set to OutOfService.
Removing a SDV-Enabled Service Group Via the DNCS
Perform the following steps to remove a SDV-enabled service group on the USRM
via the DNCS.
1 Access the Service Group Data - Open Service Group screen.
2 Set the Primary SDV Server field to None.
3 Recommended optional step: If a service group is being migrated as-is to
via the DNCS.
1 Access the Service Group Data - Open Service Group screen.
2 Set the Primary SDV Server field to None.
3 Recommended optional step: If a service group is being migrated as-is to
another USRM, then leave the QAM carriers in the Selected Ports window and
leave the mini-carousel IP address. If the service group is being eliminated, then
remove both completely.
leave the mini-carousel IP address. If the service group is being eliminated, then
remove both completely.
4 Click Save Service Group to save your changes.
5 Monitor the EventLog to verify that the SNMP commands are sent by the DNCS.
6 Select the Applications - SdvSm - ServiceGroups/Config page and verify that the
5 Monitor the EventLog to verify that the SNMP commands are sent by the DNCS.
6 Select the Applications - SdvSm - ServiceGroups/Config page and verify that the
service group does not appear in the table.
Modifying and Running the Qams_Servername.txt File
Note: This procedure assumes that the QAMs_Servername.txt file is already loaded
in the AutoConfigFileName field and will automatically load and run once the file is
modified.
1 Open an xterm window on the USRM.
2 Change to the /opt/usrm/ConfigFiles directory.
3 Replace the contents of the QAMs_Servername.txt file with the contents of the
in the AutoConfigFileName field and will automatically load and run once the file is
modified.
1 Open an xterm window on the USRM.
2 Change to the /opt/usrm/ConfigFiles directory.
3 Replace the contents of the QAMs_Servername.txt file with the contents of the
QAMs_Servername_sgDelete.txt file.