Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 3 USRM Web Interface
58
4039132 Rev B
ConfigManager - Software Upgrade Page
The Software Upgrade page provides controls to upgrade the software. A new
version of the software can be obtained as an rpm file. The rpm file contains all of the
components that are to be upgraded in the new release. Other file types can be
downloaded but upgrade of the software is only supported using an rpm file.
version of the software can be obtained as an rpm file. The rpm file contains all of the
components that are to be upgraded in the new release. Other file types can be
downloaded but upgrade of the software is only supported using an rpm file.
To initiate a software upgrade, set all necessary parameters on the Software Upgrade
page and click Commit Changes.
page and click Commit Changes.
The following illustration shows the ConfigManager - Software Upgrade page.
Parameters
The following table explains the ConfigManager - Software Upgrade page
parameters.
parameters.
Parameter
Description
DownloadProtocol
Sets the protocol for downloading the new release of the
software. Two protocols are supported, FTP and SSH.
SSH is the default and is used when receiving an
upgrade from DNCS.
software. Two protocols are supported, FTP and SSH.
SSH is the default and is used when receiving an
upgrade from DNCS.
Note: Must have service level access to change to FTP in
versions prior to 1.6.0.
versions prior to 1.6.0.
FTPHost
Specifies the IP address of the FTP server that contains
the software upgrade file.
the software upgrade file.
FTPUserName
Specifies the user name for the account on the FTP server.