Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 3 USRM Web Interface
230
78-4021139-01 Rev D
Parameter
Description
MpegProgramHigh
The highest available MPEG program number to be
allocated. The range must be less than 1000 total program
numbers. The high range is adjusted down to enforce this
restriction.
MinActiveBandwidth
Selects the global minimum active bandwidth. The
software will always attempt to keep at least this amount
of bandwidth active with switched programs
independent of user demand. This configuration
parameter can also be configured at the service group
level. If not defined at the service group level (i.e.,
configured to zero), then this global value shall apply.
MaxActiveBandwidth
Selects the global maximum active bandwidth. The
software will attempt to keep the active bandwidth
below this threshold. The software will use all means to
limit bandwidth to this threshold unless user demand
requires more than this amount of bandwidth. This
configuration parameter can also be configured at the
service group level. If not defined at the service group
level (i.e., configured to zero), this global value will
apply.
ServiceProtection
The software provides service protection. If configured,
the software will move programs with users from a failed
QAM device to a normal status QAM device within the
same service group. This configuration parameter
enables the protection feature, as follows:
Automatic - enables resource protection.
Manual - disables resource protection.
Automatic - enables resource protection.
Manual - disables resource protection.
RecaptureTestPeriod
Selects how often the recapture algorithm is executed.
The recapture algorithm checks clients for inactivity and
sends attention notification requests to those clients that
have not shown user presence for a configured time
period.
ActiveUpdatePeriod
Determines how often the software updates the active
programs. Programs are activated to satisfy the
MinActiveBandwidth criteria. The service function that
provides this service is executed at this configured time
period.
FillReleasePeriod
The software also tests to determine if fill programs
should be released. This parameter selects how often this
function is executed.