Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

Chapter 1 Overview

78-4021139-01 Rev D

USRM Quick Start Guide

Introduction

This manual contains information and instructions on USRM hardware installation,

USRM initial setup and startup, and USRM software and system configuration.
Perform the following steps, in order, to install and configure your USRM.

Step 1 - Read System Overview

Before starting any installation or configuration procedures, you should read

through all of Chapter 1 - Overview to gain a general understanding of the operation

of the USRM.

Step 2 - Install the USRM Hardware

Physically install the USRM hardware and make all necessary rear panel

connections. Follow the detailed instructions in Hardware Installation (on page 25).

Step 3 - Perform the USRM Initial Setup Procedure

Perform the USRM initial setup by running the setup script. Follow the detailed

instructions under USRM Setup Procedure (on page 308).

Step 4 - Perform the USRM Startup Procedure

Perform the USRM startup by following the detailed instructions under USRM

Startup Procedure (on page 312).

Step 5 - Create and Configure Network Resources

Create a QAM, and then use the resource manager to configure the network

resources, e.g., QAMs, for your product-specific application. Refer to the appropriate

appendix in this manual for detailed information regarding your particular product.