Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

 

332 

78-4021139-01 Rev D 

6  Verify the edge inputs. 

Note: If only one input is to be used or if the RFGW-1 will be controlling the load 

balancing, set the Port 2 AdminState to OutOfService. If the USRM will be 

controlling the load balancing, verify or set Port 1 and Port 2 AdminState to 

InService as shown above. 

7  Select QAM <QamName> - Gbe Ports and verify these settings. 

 

 

 
Note: The example shown above is for Port Pairs. There is also an Independent 

mode in which all four ports are independent. The four-port independent mode 

is needed if the RFGW-1 is to be used as a 96-port QAM. An example of four-

port independent mode is shown below. 
 

 

 
For additional important information, see the Note on Four-Port Independent 

Mode at the end of this section. 

8  If not already done, perform steps for the RFGW-1 similar to steps 5 through 15 

shown in the GQAM example under GQAM Setup Using GQAM Model (on 

page 320). 

9  Select the ResourceManager - Service Groups Graphics page, and then select 

QamComposition - Display.