Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
UCS CIMC
78-4021139-01 Rev D
419
Configuring a Dedicated LOM Port
By default, the UCS CIMC listens on the eth0 interface of the Cisco UCS server (6 in
diagram). However, the CIMC can be assigned to its own interface (2 in diagram).
This is mandatory for the UCS CIMC to operate on a subnet different from the eth0
address of the UCS USRM software.
Follow these steps to configure the UCS CIMC to use the dedicated LOM port:
1 Connect the dedicated LOM port (2 in diagram) to the switch for the LOM
Follow these steps to configure the UCS CIMC to use the dedicated LOM port:
1 Connect the dedicated LOM port (2 in diagram) to the switch for the LOM
network.
2 If necessary, configure the UCS CIMC network settings. See
Configuring UCS
CIMC Network Settings (on page 416) for more information.
3 Access the UCS CIMC web interface. See
Accessing the UCS CIMC Web Interface
(on page 417) for more information.
4 Click the Admin tab on the left side of the UCS CIMC web GUI.
5 Click Network on the left side of the UCS CIMC web GUI.
6 Select Dedicated in the NIC Mode dropdown menu.
7 Make any network address configuration changes necessary in the IPv4
5 Click Network on the left side of the UCS CIMC web GUI.
6 Select Dedicated in the NIC Mode dropdown menu.
7 Make any network address configuration changes necessary in the IPv4
Properties, and then click Save Changes.
8 Access the UCS CIMC GUI through the new IP address.