Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 1 Overview
2
78-4021139-01 Rev D
USRM Quick Start Guide
Introduction
This manual contains information and instructions on USRM hardware installation,
USRM initial setup and startup, and USRM software and system configuration.
Perform the following steps, in order, to install and configure your USRM.
Perform the following steps, in order, to install and configure your USRM.
Step 1 - Read System Overview
Before starting any installation or configuration procedures, you should read
through all of Chapter 1 - Overview to gain a general understanding of the operation
of the USRM.
Step 2 - Install the USRM Hardware
Physically install the USRM hardware and make all necessary rear panel
connections. Follow the detailed instructions in Hardware Installation (on page 25).
Step 3 - Perform the USRM Initial Setup Procedure
Perform the USRM initial setup by running the setup script. Follow the detailed
instructions under USRM Setup Procedure (on page 308).
Step 4 - Perform the USRM Startup Procedure
Perform the USRM startup by following the detailed instructions under USRM
Startup Procedure (on page 312).
Step 5 - Create and Configure Network Resources
Create a QAM, and then use the resource manager to configure the network
resources, e.g., QAMs, for your product-specific application. Refer to the appropriate
appendix in this manual for detailed information regarding your particular product.