Cisco DNCS System Release 2.8 3.8 4.3 Guide De Montage
Chapter 3 Phase Two - Test New Software
44
78-4003052-01 Rev G
4 Click Select next to the S/W Table of Contents field. The SW TOC Selection
window opens.
Note: The SW TOC Selection window lists the software files eligible for
download into DHCTs of this type. Both the current and the new files should be
listed.
5 Select None and click OK. The SW TOC Selection window closes.
6 Click Save.
7 Repeat steps 3 through 6 for every DHCT type that you plan to upgrade that is
6 Click Save.
7 Repeat steps 3 through 6 for every DHCT type that you plan to upgrade that is
using OSM, as well as any DHCT type that will be switching to CVT as part of
this upgrade.
8 After you unassociate the last DHCT type, select File and choose Close. The
DHCT Type List window closes.
Important! At this point in the download process, you can no longer stage
Important! At this point in the download process, you can no longer stage
DHCTs that are receiving new software using OSM.
9 Open an xterm window on the DNCS.
10 Run the listOSM utility. See
10 Run the listOSM utility. See
Run listOSM Utility (on page 22) for more
information.
Note: The output of this script helps you to determine which files are no longer
Note: The output of this script helps you to determine which files are no longer
required.
11 On the DNCS Administrative Console, select the DNCS tab and then select the
following tab based on the system release you have installed:
For SR 2.2/3.2/4.0 and earlier, select the Element Provisioning tab.
For SR 2.5/3.5/4.2 and later, select the Home Element Provisioning tab.
12 Click OS.
13 Highlight the file name and select Delete for each DHCT software file in step 10
13 Highlight the file name and select Delete for each DHCT software file in step 10
that is identified as unused.
Important! Do not delete files with different naming formats such as .rle, .res, or
Important! Do not delete files with different naming formats such as .rle, .res, or
.dat. These files are used by other functions such as logos and configuration files.
Note: The DHCT software files typically have file extensions of .ver, _0, and _1.
Note: The DHCT software files typically have file extensions of .ver, _0, and _1.