Cisco Cisco RF Gateway 10

Boot the Cisco IOS software image. This may happen automatically if the system is configured to 
auto-boot.

On a redundant system, hook up a console to the now-standby Supervisor engine. After the system 
achieves an SSO state, repeat steps 6-8.

Use the show version command to verify that you have upgraded the ROMMON:

switch#show version

Cisco IOS Software, Catalyst 4500 L3 Switch Software (rfgw-ENTSERVICES-M), Version 

12.2(50)SQ1, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2009 by Cisco Systems, Inc.

Compiled Fri 13-Nov-09 16:39 by prod_rel_team

Image text-base: 0x10000000, data-base: 0x1205CF10

ROM: 12.2(31r)SQ1

Lemmy Revision 62, Force Revision 31, Tie Revision 32

RFGW-10 uptime is 0 minutes

Uptime for this control processor is 0 minutes

System returned to ROM by power-on

System image file is "tftp://223.255.254.254/mjagatap/rfgw-entservices-mz.122-50.SQ1"

cisco Cable-RFGW (MPC8540) processor (revision 11) with 524288K bytes of memory.

Processor board ID NWG113002RG

MPC8540 CPU at 800Mhz, Supervisor V-10GE

Last reset from Reload

1 Virtual Ethernet interface

14 Gigabit Ethernet interfaces

4 Ten Gigabit Ethernet interfaces

511K bytes of non-volatile configuration memory.

...

Use the delete command on the active Supervisor to delete the PROM upgrade program from bootflash.

The following example shows how to delete RFGW-X4516-10GE-RMUW-122_31r_SQ1 image from 
bootflash:

Switch# delete bootflash:RFGW-X4516-10GE-RMUW-122_31r_SQ1

On a redundant system, also delete the upgrade file from the standby Supervisor engine. 

Switch# delete slavebootflash:RFGW-X4516-10GE-RMUW-122_31r_SQ1

The ROMMON has now been upgraded.

The following sections describe the documentation available for the Cisco RFGW-10 platform. 

These documents are available for the Cisco RF Gateway 10 platform on Cisco.com: