Cisco Cisco RF Gateway 10
22
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
Caveats
CSCud09247
Symptoms: FastEthernet1 port and VLAN interfaces go to down
state after replacing the saved configuration with a running
configuration on the Cisco RFGW-10 router.
state after replacing the saved configuration with a running
configuration on the Cisco RFGW-10 router.
Conditions: This issue occurs when the Cisco RFGW-10 is reloaded
and the saved configuration is replaced with the running
configuration.
and the saved configuration is replaced with the running
configuration.
Workaround: Use the no shut command to unshut the ports.
CSCud16912
Symptoms: The compact flash size is displayed incorrectly on
standby Supervisor card.
standby Supervisor card.
Conditions: This issue occurs after swapping the compact flashes
between the active and standby Supervisor cards.
between the active and standby Supervisor cards.
Workaround: There is no workaround.
CSCud19522
Symptoms: The standby Supervisor card goes to Route Processor
Redundancy (RPR) mode after a switchover.
Redundancy (RPR) mode after a switchover.
Conditions: This issue occurs when line cards are removed from a
line card redundancy group configuration, and supervisor
switchover is initiated using the redundancy force-switchover
command on the Cisco RFGW-10 router.
line card redundancy group configuration, and supervisor
switchover is initiated using the redundancy force-switchover
command on the Cisco RFGW-10 router.
Workaround: There is no workaround.
CSCud38529
Symptoms: Data plane DEPI sessions status does not become active
when Cisco RFGW-10 DS48 line card becomes operational after it
is reset.
when Cisco RFGW-10 DS48 line card becomes operational after it
is reset.
Conditions: This issue occurs when the stand-alone TCC card reset
without a standby TCC card.
without a standby TCC card.
Workaround: Reset the Cisco RFGW-10 DS-48 line card.
CSCud65515
Symptoms: Primary DEPI session do not go to the up state for some
QAM channels on the Cisco RFGW-10.
QAM channels on the Cisco RFGW-10.
Conditions: This issue occurs when invalid RF power range exists
for the QAM channels causing loss of DEPI sessions on the QAM
channel.
for the QAM channels causing loss of DEPI sessions on the QAM
channel.
Workaround: Deconfigure and configure the DEPI tunnel for the
QAM channel. This should bring up the DEPI sessions.
QAM channel. This should bring up the DEPI sessions.
CSCud14476
Symptoms: Modems come to the online state instead of w-online
state after the primary line card is reset or switched over.
state after the primary line card is reset or switched over.
Conditions: This issue occurs when the following conditions exist:
•
No physical connection exists between the secondary line card
and the CMTS
and the CMTS
•
Revertive time is set in the redundancy configuration
Workaround: There is no workaround.
Caveat
Description