Cisco Cisco StadiumVision Director Manuel De Maintenance
Table 4. DMP-2K Front Panel Port Descriptions
Port Name
Usage
Description
Audio
1
Required only for connections that do not support
audio, such as HDMI-to-DVI connections from
device to the TV.
audio, such as HDMI-to-DVI connections from
device to the TV.
3.5 mm female audio
connector for analog stereo
signal.
connector for analog stereo
signal.
IR
The DMP-2K does not have an internal infrared
receiver. You must use the included IR extender
cable to support an IR remote.
receiver. You must use the included IR extender
cable to support an IR remote.
3.5 mm infrared in/out.
Serial
Connect to TV serial port for control of the TV via
RS-232 commands.
RS-232 commands.
RS-232 serial interface with
male DE-9 connector. This
connection is used for
TV control.
male DE-9 connector. This
connection is used for
TV control.
Figure 3. DMP-2K Rear Panel
Table 5. DMP-2K Rear Panel Port Descriptions
Port Name
Usage
Description
12V 5A
Not for production use in
Cisco StadiumVision Director.
Cisco StadiumVision Director.
NOTE: The DMP-2K is qualified for Cisco
StadiumVision Director using Power over
Ethernet (PoE+) via the Ethernet port.
StadiumVision Director using Power over
Ethernet (PoE+) via the Ethernet port.
60-watt/12-volt/5-amp power supply.
SPDIF
Provides audio from the primary video
routed by Cisco StadiumVision
Director to the SPDIF port.
routed by Cisco StadiumVision
Director to the SPDIF port.
Sony/Phillips Digital Interface.
HDMI
Connect to HDMI In port on the TV.
High-Definition Multimedia Interface
(HDMI) output connector to transmit digital
audio/video content.
(HDMI) output connector to transmit digital
audio/video content.
1
The analog audio out port is designed to drive line-level impedances in the higher Ohm range, such as
for commercial grade speaker systems. Headphones are typically just a few Ohms and not recommended
for use with this port.
for use with this port.
© Cisco Systems, Inc. All rights reserved.
5 of 80