Cisco Cisco StadiumVision Mobile Manuel De Maintenance
© 2011 Cisco Systems, Inc. All rights reserved.
Page 88 of 103
Configuring Civic Location in the Switch
IOS civic location is a collection of labels that can be configured on each switch
port, and then communicated to the DMP via CDP. One use case for civic location
is jack ID, hence allowing the DMP to learn what Ethernet jack it is connected to.
The DMP reports any civic location information it learns back to Cisco
StadiumVision Director, where it can be retrieved and displayed by Cisco
StadiumVision Director as shown above. It can also be viewed directly in the DMP’s
web interface.
port, and then communicated to the DMP via CDP. One use case for civic location
is jack ID, hence allowing the DMP to learn what Ethernet jack it is connected to.
The DMP reports any civic location information it learns back to Cisco
StadiumVision Director, where it can be retrieved and displayed by Cisco
StadiumVision Director as shown above. It can also be viewed directly in the DMP’s
web interface.
The following example shows the civic location being configured and applied to
interface gigabit Ethernet 0/5:
interface gigabit Ethernet 0/5:
Training_SW#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Training_SW(config)#location civic-location identifier 1
Training_SW(config-civic
Enter configuration commands, one per line. End with CNTL/Z.
Training_SW(config)#location civic-location identifier 1
Training_SW(config-civic
)#?
Type ? to see all the options of configuring the location.
Training_SW(config-civic)#additional-location-information POD1
Training_SW(config-civic)#building C
Training_SW(config-civic)#floor 2
Training_SW(config-civic)#room Cookie_Monster
Training_SW(config-civic)#end
Training_SW#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Training_SW(config)#int g0/5
Training_SW(config-if)#location civic-location-id 1
Training_SW(config-if)#end
Training_SW(config-civic)#building C
Training_SW(config-civic)#floor 2
Training_SW(config-civic)#room Cookie_Monster
Training_SW(config-civic)#end
Training_SW#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Training_SW(config)#int g0/5
Training_SW(config-if)#location civic-location-id 1
Training_SW(config-if)#end