Cisco Cisco StadiumVision Mobile Streamer Manuel De Maintenance
© 2011 Cisco Systems, Inc. All rights reserved.
Page 34 of 94
Chapter 3 DMP Deployment
This section describes how to deploy Cisco 4310G Digital Media Players (DMPs)
using StadiumVision 2.3. The workflow described includes the auto registration and
provisioning of the DMP and how to map the DMP to a physical Location Name
within StadiumVision Director. This workflow gets the DMP to the “In Production”
state where it is ready to be assigned to its appropriate Groups and Zones where
specific content is assigned for display throughout the venue. This DMP assignment
to Groups and Zones will be described in another document.
using StadiumVision 2.3. The workflow described includes the auto registration and
provisioning of the DMP and how to map the DMP to a physical Location Name
within StadiumVision Director. This workflow gets the DMP to the “In Production”
state where it is ready to be assigned to its appropriate Groups and Zones where
specific content is assigned for display throughout the venue. This DMP assignment
to Groups and Zones will be described in another document.
Installation Prerequisite Steps
1. Enable Auto-Registration and Provisioning in SV Director 2.3.
2. Configure a switch port for DMP (Not covered in this document).
3. Configure a DHCP Server for DMP Auto Registration and Provisioning.
4. Set the Default Video Channel.
5. Configure TV RS-232 Codes for TV Control.
6. Determine the TV location and naming convention.
2. Configure a switch port for DMP (Not covered in this document).
3. Configure a DHCP Server for DMP Auto Registration and Provisioning.
4. Set the Default Video Channel.
5. Configure TV RS-232 Codes for TV Control.
6. Determine the TV location and naming convention.
Installation Steps
1. Install the TV and DMP. During installation:
The DMP gets network information via DHCP.
The SV Director learns about DMP (auto-registration or manual CSV
upload).
2. Provision the DMP for production (auto or manual provisioning).
3. Link the DMP and Location.
4. Assign the DMP to a specific group/zone.
3. Link the DMP and Location.
4. Assign the DMP to a specific group/zone.