Cisco Cisco StadiumVision Mobile Streamer Manuel De Maintenance
© 2011 Cisco Systems, Inc. All rights reserved.
Page 77 of 94
Figure 69.
Adjusting the TV‟s Aspect Ratio
Note:
TVs typically will retain settings made via their Settings menu. However, if an
equivalent RS-232 control command is supported, StadiumVision Director may
be used to set this on the TV upon script initiation or for doing a bulk setting
across a number of DMP-connected TVs. See
be used to set this on the TV upon script initiation or for doing a bulk setting
across a number of DMP-connected TVs. See
Some older TVs do not have the ability to adjust for overscan. If the picture
requires adjustment, the DMP provides a way to scale and position the picture.
See
See
Resetting Overscan on Older TVs
.
DNS Settings
DNS settings are not required for the DMP to operate in the StadiumVision solution.
In fact, if the DMP is configured with a DNS server that is unreachable, the solution
will not function properly. Therefore, it is recommended that you disable DNS on the
DMPs.
In fact, if the DMP is configured with a DNS server that is unreachable, the solution
will not function properly. Therefore, it is recommended that you disable DNS on the
DMPs.
Setting a Blank TV Channel
Situation: For some events (such as concerts), it may be desirable to display
content only on certain TVs and have the other TVs black or off.
content only on certain TVs and have the other TVs black or off.
Challenge: StadiumVision Director does not allow for the selective powering of
TVs.
TVs.
Solution: As an alternative to selectively turning TVs off, you can tune these TVs to
a blank channel, which will result in the same effect
a blank channel, which will result in the same effect
– a black screen.