Cisco Prisma II 1310 nm HDTx Transmitters Guide De Montage
Chapter 3 Operation using ICIM
68
To Change Parameters
Below is an example dialog where one of the parameters (Trap Community) is
changed. Any of the parameters can be changed, although some should be changed
only with the advice of Cisco services.
changed. Any of the parameters can be changed, although some should be changed
only with the advice of Cisco services.
Note: Hardware parameters (serial channel baud rate, serial number, and board
Ethernet address) should not be changed.
Ethernet address) should not be changed.
Each time a prompt is given, the default value is displayed in square brackets.
1 Press Enter to retain the current value and move onto the next parameter.
1 Press Enter to retain the current value and move onto the next parameter.
Note: As an example in the above screen, the Trap Community string has been
changed to a new value. The prompt for delay time is the last one before the
summary screen is presented.
changed to a new value. The prompt for delay time is the last one before the
summary screen is presented.
2 Press any key repeatedly until the following prompt appears.
3 Press Enter to get the default value for Modify.
To Restart the ICIM using ICIM
The boot selection dialog appears again.
1 Select 3 to indicate that the normal ICIM application should be run (instead of
TFTP).
Result: The summary page appears.
Result: The summary page appears.
2 Do nothing and when the 5 second timeout expires, the ICIM restarts normally.