Cisco Cisco Prime Network Services Controller 3.0
© 2013, 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 157 of 169
Step 4 scope syslog
Example:
nsc(policy-mgr) /org/policy # scope log
EaLogPA11
Places you in log mode.
Step 5 enable monitor
Example:
nsc(policy-mgr) /org/policy/syslog # enable
monitor
Enables the monitor.
Step 6 commit-buffer
Example:
nsc /system/backup* # commit-buffer
Commits (saves) the
configuration.
configuration.
EXAMPLES
This example shows how to enable the monitor:
nsc# connect policy-mgr
Cisco Prime Network Services Controller
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained in this software are
owned by other third parties and used and distributed under
license. Certain components of this software are licensed under
the GNU General Public License (GPL) version 2.0 or the GNU
Lesser General Public License (LGPL) Version 2.1. A copy of each
such license is available at
http://www.opensource.org/licenses/gpl-2.0.php and
http://www.opensource.org/licenses/lgpl-2.1.php
nsc(policy-mgr)# scope org
nsc(policy-mgr) /org # scope policy
nsc(policy-mgr) /org/policy # scope syslog EaSysPA12
nsc(policy-mgr) /org/policy/syslog # enable monitor
nsc(policy-mgr) /org/policy/syslog* # commit-buffer
nsc(policy-mgr) /org/policy/syslog #
Disabling the Monitor
You can disable the monitor.
BEFORE YOU BEGIN
Services Controller CLI.
CLI
Policy Manager
SUMMARY STEPS
1. connect policy-mgr
2. scope org