Cisco Cisco Prime Network Services Controller 3.0

 

 

© 2013, 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. 

Page 76 of 169 

This example shows how to reset the management logging levels in the resource manager CLI: 

nsc # connect resource-mgr 

Cisco Prime Network Services Controller 

TAC support: http://www.cisco.com/tac 

Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved. 

The copyrights to certain works contained in this software are 

owned by other third parties and used and distributed under 

license. Certain components of this software are licensed under 

the GNU General Public License (GPL) version 2.0 or the GNU 

Lesser General Public License (LGPL) Version 2.1. A copy of each 

such license is available at 

http://www.opensource.org/licenses/gpl-2.0.php and 

http://www.opensource.org/licenses/lgpl-2.1.php 

nsc (resource-mgr)# scope monitoring 

nsc (resource-mgr) /monitoring # scope sysdebug 

nsc (resource-mgr) /monitoring/sysdebug # scope mgmt-logging 

nsc (resource-mgr) /monitoring/sysdebug/mgmt-logging # save 

nsc (resource-mgr) /monitoring/sysdebug/mgmt-logging # 

Displaying Management Logs 

You can display management logs. 

See 

 for basic information about the Prime Network 

Services Controller CLI. 

Management controller 

Policy manager 

Resource manager 

Service registry 

Virtual machine manager 

1.  (Optional) connect {policy-mgr | resource-mgr | service-reg | vm-mgr} 

Note Step 1 is optional. You can also perform the show command in the management controller CLI. 
Each CLI allows you to control a different set of logs.