Cisco Cisco Prime Network Services Controller 3.0
© 2013, 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Page 92 of 169
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained in this software are
owned by other third parties and used and distributed under
license. Certain components of this software are licensed under
the GNU General Public License (GPL) version 2.0 or the GNU
Lesser General Public License (LGPL) Version 2.1. A copy of each
such license is available at
http://www.opensource.org/licenses/gpl-2.0.php and
http://www.opensource.org/licenses/lgpl-2.1.php
nsc(policy-mgr)# scope org
nsc(policy-mgr) /org # scope deviceprofile default
nsc(policy-mgr) /org/deviceprofile # set corefile EaCorePA13
nsc(policy-mgr) /org/deviceprofile* # commit-buffer
nsc(policy-mgr) /org/deviceprofile #
Setting the Fault Policy
You can set the fault policy.
BEFORE YOU BEGIN
Services Controller CLI.
CLI
Policy Manager
SUMMARY STEPS
1. connect policy-mgr
2. scope org
3. scope deviceprofile <profile-name>
4. set faultpolicy <policy-name>
5. commit-buffer
DETAILED STEPS
Command
Purpose
Step 1 connect policy-mgr
Example:
nsc# connect policy-mgr
Places you in the policy manager
CLI.
CLI.
Step 2 scope org
Example:
nsc(policy-mgr)# scope org
Places you in organization mode.
Step 3 scope deviceprofile
Example:
nsc(policy-mgr) /org # scope deviceprofile
default
Places you in device profile mode.