Cisco Cisco OptoStar II 1550nm Transmitter Guide De Montage
Console-Module Control Interface, Continued
Setup Parameters
The table below lists the setup parameter of the OptoStar II reverse receiver
module.
module.
Setup
Parameters
Description
Factory Default
Optical Alarm
Threshold
Shows/sets optical alarm upper
limit and lower limit
Lower limit: - 17.0
dB
Upper limit: + 3.0
dB
Module Alarm
Options
Display/set module alarm options
Four-way modules
are all in ON status
Test Point
Display/set test points for different
modules
No test point
Alarm ON/OFF
Shows/sets module alarm status:
ON/OFF
The Alarm ON/OFF corresponds to
The Alarm ON/OFF corresponds to
the selection of module alarm status,
for example: When you only need to
monitor Module 1 and Module 2, the
Alarm ON/OFF for Module 1 and
Module 2 will be switched to ON.
Alarm status: ON
Four-Way
Module Gain
Control Mode
Shows/sets AGC or MGC gain
control mode
Four-way modules
are all in AGC mode
(gain in MGC mode
(gain in MGC mode
is set to 0 dB)
Continued on next page
OL-29664-05
Operation
3-27